- Messages
- 2,643
- Reactions
- 3,172
Tonight I installed the last (until the next upgrade) of the Rockler T Track system on my bench.
I bought some ¼" T Track bolts which fit perfectly through the base of the Inline Fabrication Ultra-Mount. I then use four Rockler screw down cam-locks on each corner, and everything is absolutely rock solid!
With the tracks in place, I can loosen the cam-locks and slide the press out of the way, or even remove it from the bench altogether. I'm also going to make mounting plates out of plywood so I can mount other tools to the track system as well. This system also leaves it wide open for adding a progressive press when the time comes!
I bought some ¼" T Track bolts which fit perfectly through the base of the Inline Fabrication Ultra-Mount. I then use four Rockler screw down cam-locks on each corner, and everything is absolutely rock solid!
With the tracks in place, I can loosen the cam-locks and slide the press out of the way, or even remove it from the bench altogether. I'm also going to make mounting plates out of plywood so I can mount other tools to the track system as well. This system also leaves it wide open for adding a progressive press when the time comes!