- Messages
- 257
- Reactions
- 282
For me...all range brass gets stored in a bin, nice tall yellow bins that cat litter comes in. Once I am low on RTL(Ready to Load) brass I run a batch, usually 1k-1.2k cases. They are run quickly in my tumbler(no ss pins) to remove dirt/grime and keep my dies nice. Then they are lubed by hand giving me a chance to inspect them and put through my 650 and deprimed, sized, and trimmed. Then they are tumbled in stainless pins/dawn/lemishine/ and a few drops of degreaser. Once dried they are stored in bags until I load them.
Once I'm ready to load them they go through my 1050, swaged, primed, charged with H335, seated, and crimped. I only load 55gr and have been using xtreme but with the prices I have seen them at I think once my stock is low I'll start using Hornady.
Once I'm ready to load them they go through my 1050, swaged, primed, charged with H335, seated, and crimped. I only load 55gr and have been using xtreme but with the prices I have seen them at I think once my stock is low I'll start using Hornady.