Silver Supporter
Bronze Lifetime
- Messages
- 2,033
- Reactions
- 5,722
- Thread Starter
- #121
Is this method consistent if the cases are different trim lengths? All the .223 cases I've trimmed so far are trimmed to 1.755" max. Some were less and didn't need trimming. If the case length varies, do I need to reset the dies? I haven't gotten that far yet.I should add that you can adjust your seating and/or crimping dies by just screwing them down snugly on top of the pattern cartridge you made. It can expedite the die set up quite a lot.