- Messages
- 2,755
- Reactions
- 3,490
Made this little stainless tray out of some scrap 16ga. And some hi force 44 solder. Super glued a couple neo magnets to the bottom and also underneath the trimmer so it stays put.
Not 100% effective as those little turnings do fly occasionally but it catches about 95% of them or better. Good enough without getting in the way.
Pardon the mess, i am "afflicted" as im sure alot of you (ok maybe just some) can relate.
P.s. i also made the table! Come to think of it. Its the old Pacific raceways sign that was off of hwy 18 i found it in the scrap wood pile at the PUD off of west valley in kent.
Kinda cool, waste not want not.
Not 100% effective as those little turnings do fly occasionally but it catches about 95% of them or better. Good enough without getting in the way.
Pardon the mess, i am "afflicted" as im sure alot of you (ok maybe just some) can relate.
P.s. i also made the table! Come to think of it. Its the old Pacific raceways sign that was off of hwy 18 i found it in the scrap wood pile at the PUD off of west valley in kent.
Kinda cool, waste not want not.