- Messages
- 42,831
- Reactions
- 111,255
- Thread Starter
- #41
The best way to do this IMO - is if you are at all skilled/experienced in fabrication/etc. - is to have the raw materials (Not a kit like this) and drawings/plans/etc. to fabricate such mechanisms yourself.
Also, eventually table top "maker" 3D printing tools and supplies will get to the point where this is possible.
Personally, I don't really have a compelling need for a full auto pistol - as much fun as it would be to shoot one. At $1/round currently for ammo, I wouldn't shoot a 33 round stick more than once anyway.
The only tactical situation I could think of where that would be a possible advantage - maybe - would be if I were overrun by multiple assailants at close quarters, my long gun was no longer functioning and all I had left was a full auto pistol with a large cap mag (more than 20 rounds). Even then, I would probably be better off just shooting semi-auto as fast as I could.
To me - it isn't worth the possibility of spending time in a federal pound me in the anal orifice prison.
Also, eventually table top "maker" 3D printing tools and supplies will get to the point where this is possible.
Personally, I don't really have a compelling need for a full auto pistol - as much fun as it would be to shoot one. At $1/round currently for ammo, I wouldn't shoot a 33 round stick more than once anyway.
The only tactical situation I could think of where that would be a possible advantage - maybe - would be if I were overrun by multiple assailants at close quarters, my long gun was no longer functioning and all I had left was a full auto pistol with a large cap mag (more than 20 rounds). Even then, I would probably be better off just shooting semi-auto as fast as I could.
To me - it isn't worth the possibility of spending time in a federal pound me in the anal orifice prison.
