- Messages
- 103
- Reactions
- 82
Hello folks, i wave recently inherited about 20 sets of older rcbs and Redding dies with 2 presses that have smaller spots of surface rust. I did a quick scan and didn't see this topic so am asking here.
The rust is not enough to retire the dies and i would like to save them as spares for what i already reload and some that i will reload in the future. I'm hoping that i can buy something in bulk and soak them - then a little scrubbing. rather than treat each spot on each die separately. Each die has multiple spots and with 40-50 individual dies, that could take some effort.
Any ideas are appreciated, even if your just voting yes or reccomending on something already mentioned.
The rust is not enough to retire the dies and i would like to save them as spares for what i already reload and some that i will reload in the future. I'm hoping that i can buy something in bulk and soak them - then a little scrubbing. rather than treat each spot on each die separately. Each die has multiple spots and with 40-50 individual dies, that could take some effort.
Any ideas are appreciated, even if your just voting yes or reccomending on something already mentioned.