- Messages
- 84
- Reactions
- 40
Hello,
Bought a sig 556 swat and finally found some rounds to go try it out. I was using some tapco 30 round mags loaded with a mix of 5.56 and .223. The rounds would hang up and in two cases the bullet was pushed back into the brass. Later I took some fresh 223 and was cycling through the rife and had the same problem. It seems like the mag is riding low and when I push it up a hair the round cycle through properly. Tried it with an aluminum gi mag and no problem. So is it the the tapco mag or is there some adjustment to the rifle or breaking in issue?
Thanks
Bought a sig 556 swat and finally found some rounds to go try it out. I was using some tapco 30 round mags loaded with a mix of 5.56 and .223. The rounds would hang up and in two cases the bullet was pushed back into the brass. Later I took some fresh 223 and was cycling through the rife and had the same problem. It seems like the mag is riding low and when I push it up a hair the round cycle through properly. Tried it with an aluminum gi mag and no problem. So is it the the tapco mag or is there some adjustment to the rifle or breaking in issue?
Thanks