80% Lower

Discussion in 'General Firearm Discussion' started by taylor, Jan 13, 2013.

  1. taylor

    taylor
    Willamette Valley
    Well-Known Member

    Messages:
    1,134
    Likes Received:
    150
    Anybody here bought one? Are they hard to finish with the molds for the hole placements?
     
  2. mikeskar

    mikeskar
    marysville
    New Member

    Messages:
    13
    Likes Received:
    0
    They are not that easy and u need a mini mill
     
  3. gehrheart

    gehrheart
    fidalgo island
    Well-Known Member

    Messages:
    1,261
    Likes Received:
    418
    you dont "need" a mini mill..
    But it does make it a whole lot nicer!

    They really are not worth the time or effort. Other then to say, yep I did it!
     
  4. HahnsXD

    HahnsXD
    Battle Ground WA
    Active Member

    Messages:
    382
    Likes Received:
    69
    I just milled mine yesterday. I just used blueprints, no jig. The FCG pocket came out great but the hole placement isn't perfect, but should work fine none the less. If you don't have access to a mill or experience with a mill I would shy away from it.

    2013-01-12_10-05-34_491.jpg
     
  5. samuelm16

    samuelm16
    se pdx
    Well-Known Member

    Messages:
    844
    Likes Received:
    259
    Check out ares armor they have a jig that allows you to finnish there 80 with just a drill press
     

Share This Page