I have been shooting for a long time and I have never had a NF scope. So i had the chance and bought this 5.5x22 zero stop model. It has a frustrating problem. I shoot a 3 shot group and watch the group go 1in right of POI, SO I adjust it to go 4 clicks left (YES I AM SURE I TURNED IT THE RIGHT WAY IT SAYS SO ON THE SCOPE RING) (.25moa per click) and.......it moves 1 in to the right of the previously fired shots WTF! so then I adjust to go 2inches left (8 clicks) and now I am punching holes 1in left of center!. Pulled the base off and reinstalled with blue loctite and to correct torque settings with my Weaver torque screwdriver. I am using a Leupold base and 30mm rings.
Go to shoot and the same damn game starts...... It eventually gets on POI but this is a $2000 dollar scope and better click in on the turns or its crap. When I correct for windage in the field it better damn well adj where i put it
Has anyone have something constructive to add? is this typical for these scopes to be tight and need a break in?? like run through 40 moa a couple of times and then try it???
Go to shoot and the same damn game starts...... It eventually gets on POI but this is a $2000 dollar scope and better click in on the turns or its crap. When I correct for windage in the field it better damn well adj where i put it
Has anyone have something constructive to add? is this typical for these scopes to be tight and need a break in?? like run through 40 moa a couple of times and then try it???