Lee full lenght sizing die (223)

Discussion in 'Ammunition & Reloading' started by Silver02ex, Feb 18, 2012.

  1. Silver02ex

    Silver02ex
    Hillsboro, OR
    Member

    Messages:
    103
    Likes Received:
    11
    I had a stuck case in my full lenght sizing die. I got it out after following Lee's direction. There was no issue putting the decaping pin back in. Is there a certain depth should the decaping pin go in on the body? There doesn't seem to be an issue with the new case after I put it in the case gauge. I assume the top of the decaping pin should be flushed with the collet nut?
     
  2. Throckmorton

    Throckmorton
    Florence,Ore ah gone
    Well-Known Member

    Messages:
    1,398
    Likes Received:
    203
    I don't think it matters as long as the pin protrudes enuf to pop the primer out.If it hangs too far out it might interfere with inserting the case into the press is all.
     

Share This Page