- Messages
- 2,405
- Reactions
- 577
What is your preferred bedding material for that ultimate bedding job?
Acraglas?
Marine-Tex?
Devcon?
J-B Weld
I've recently bedded a couple of rifles, one 1903 Springfied 30-06 and another a Remington in .308 using Devcon 10110. I like it a lot as it's not "drippy", cures solid, and is also machinable so I can mill out the mag box/trigger inletting for a nice finished look.
What are YOUR preferences and why you like them best?
A note on J-B Weld (regular, not quick cure) I like it for bedding one-piece picatinny scope rails. Only need a small amount so it's easier to mix than the Devcon which is best done with a scale for proper proportions.
Acraglas?
Marine-Tex?
Devcon?
J-B Weld
I've recently bedded a couple of rifles, one 1903 Springfied 30-06 and another a Remington in .308 using Devcon 10110. I like it a lot as it's not "drippy", cures solid, and is also machinable so I can mill out the mag box/trigger inletting for a nice finished look.
What are YOUR preferences and why you like them best?
A note on J-B Weld (regular, not quick cure) I like it for bedding one-piece picatinny scope rails. Only need a small amount so it's easier to mix than the Devcon which is best done with a scale for proper proportions.