Finished my PSL, The Dragon-Off

Discussion in 'General Firearm Discussion' started by NorthernBornRebel, Apr 14, 2010.

  1. NorthernBornRebel

    NorthernBornRebel
    Keizer
    Member

    Messages:
    265
    Likes Received:
    5
    WedApr14211938AmericaLos_Angeles201.jpg

    Barrel is 13.25" long with a 3" muzzle brake. Total barrel length measured from the end of the muzzle brake to the breech face is 16.25"
     
  2. raftman

    raftman
    Oregon
    Well-Known Member

    Messages:
    1,159
    Likes Received:
    440
    Intriguing... to say the least. Wonder what the felt recoil is like.
     
  3. trainsktg

    trainsktg
    Portland OR
    Well-Known Member

    Messages:
    2,672
    Likes Received:
    824
    That's interesting. There have been several of these short barrelled PSLs to come out over the last few years, but your addition of a folding stock makes more sense than the fixed stocks the commercial products had. It looks pretty good. Presumably since you added a long enough muzzle brake to exceed an overall length of 16" that this isn't an SBR.

    Keith
     
  4. Silver Fox

    Silver Fox
    Puyallup, WA
    Well-Known Member

    Messages:
    2,187
    Likes Received:
    300
    God Bless America!

    Looks good! :thumbup:

    SF-
     
  5. wayoutwest

    wayoutwest
    Polk County, Oregon
    Active Member

    Messages:
    680
    Likes Received:
    92
    Looks good.
     
  6. eldbillbo

    eldbillbo
    clackamas
    New world samurai and a redneck none the less

    Messages:
    3,250
    Likes Received:
    1,138
    Nice

    was it built from a kit or did you convert it

    and if converted did you pull and reinstall the rear trunnion or modify existing one

    what FCG did you use a standard tapco ak fcg?

    how did you modify it to be able to install standard ak47 handgaurds?


    thats way cool
     
  7. NorthernBornRebel

    NorthernBornRebel
    Keizer
    Member

    Messages:
    265
    Likes Received:
    5
    It was built from a kit and a Nodak receiver which has a square cut back so you can use standard AK furniture. The barrel was cut to 13" and I had to redrill the pin holes for the front sight, gas block and the notch for the handguards. The handguards then needed a bit of modification done on the back end to fit properly. Rear trunnion is the original one. It uses a Tapco FCG.
     
  8. jordanka16

    jordanka16
    Albany, OR
    Well-Known Member

    Messages:
    958
    Likes Received:
    408
    Pretty sweet NBR, I am officially jealous :D
     
  9. doobee8

    doobee8
    Salem, OR
    Bronze Supporter Bronze Supporter

    Messages:
    462
    Likes Received:
    43
  10. cetme

    cetme
    oregon city
    Member

    Messages:
    473
    Likes Received:
    5
    i just got back from the gunshow.actually held it.awesome work.looks factory throughout.ill be in contact for some work in the future great job!
     

Share This Page