Silver Lifetime
- Messages
- 2,172
- Reactions
- 1,554
Well, I just got a Dillon 650, and I ran into a little hang-up while trying to set up my dies. I had been using Hornady split die lock rings, which I think are the best, at least for single stage. The issue is with the clearance on the Dillon toolhead between dies. I don't have enough room to get a wrench on the larger Hornady rings. I suppose I could dig out my old RCBS rings, but should I just do it right and use Dillon rings, along with their 1" wrench to tighten them? That's what it's designed for, after all.
Additionally, would anyone know where I could get Dillon rings without having to call them and place an order? I want to start cranking out rounds immediately! Or, if anyone has Three (3) they could part with in sale or trade, that would at least hold me over until I can get more. Thanks!
Additionally, would anyone know where I could get Dillon rings without having to call them and place an order? I want to start cranking out rounds immediately! Or, if anyone has Three (3) they could part with in sale or trade, that would at least hold me over until I can get more. Thanks!