I'll relatively new to reloading and just finshed setting up my reloading equipment. (XL 650)
After experimenting, learning, calibrating, etc., I'm left with a few errors:
Some have the primer upside down, some are seated too high because there was powder residue in the primer pocket first.
I've learned and corrected the proceedure which led up to this but need the following help as it's not in any of the manuals.
How do you safety remove these unfired primers? Seems if I run them through the machine, the de-capping die could set off the primer. Or, do the primers need a fast strike to make them go bang?
Thanks for any help here.
After experimenting, learning, calibrating, etc., I'm left with a few errors:
Some have the primer upside down, some are seated too high because there was powder residue in the primer pocket first.
I've learned and corrected the proceedure which led up to this but need the following help as it's not in any of the manuals.
How do you safety remove these unfired primers? Seems if I run them through the machine, the de-capping die could set off the primer. Or, do the primers need a fast strike to make them go bang?
Thanks for any help here.