- Messages
- 553
- Reactions
- 953
Modify your loop so that it bends down to below the ejection port. Drill a hole for each side of the loop in the scope mount. The little loops on the ends of the wire loop will catch on the far side of the scope mount and keep it from sliding out of the holes in the scope mount. The rubber band keeps tension on the loop so the ends won't slip out of the holes... but you can spread the ends apart and remove the catcher easily. No set screws or other retaining device other than the rubber band will be needed. I think I would try aluminum windows screen for the catch bag. Nylon screen might melt from powder gases.
Just a thought.
I tried to make a 3D drawing so it will probably take a bit of staring at the picture to understand the perspective.
Last Edited: