Diamond Lifetime
- Messages
- 6,124
- Reactions
- 13,917
I just bought a new $30k CNC plasma table and one of the things I hope to make are targets. I bought a 4'x8' sheet of 1/2" AR 500 and was going to make the whole thing into 12" sq gongs with two bolt holes in the upper corners to hang them. Cost would be $45 each which as far as I can tell is about 30% cheaper than what they are on line.
They should go in a medium flat rate box, probably ship 3 in a box
Probably cut the first batch later this week and I'll post pics then. Just wanted to get a feel for interest.
Also if you have any ideas about what would make good targets or want something custom let me know.
They should go in a medium flat rate box, probably ship 3 in a box
Probably cut the first batch later this week and I'll post pics then. Just wanted to get a feel for interest.
Also if you have any ideas about what would make good targets or want something custom let me know.
Last Edited: