- Messages
- 584
- Reactions
- 356
Hello everyone,
I have a KE Arms KE19 Charlie slide on my glock 19. I was installing my Ameriglo Suppressor Height Sights, using the 3/16th Glock Front Sight tool that I have from my Wheeler Engineering 89pc screw driver kit.
The wheeler glock FS bit is pretty thin walled already. But there isn't much room in the slide and I'm not getting full contact.
Any recommendations on anything thinner?
I have a KE Arms KE19 Charlie slide on my glock 19. I was installing my Ameriglo Suppressor Height Sights, using the 3/16th Glock Front Sight tool that I have from my Wheeler Engineering 89pc screw driver kit.
The wheeler glock FS bit is pretty thin walled already. But there isn't much room in the slide and I'm not getting full contact.
Any recommendations on anything thinner?