Ruger model 24 .22/.410

Discussion in 'Maintenance & Gunsmithing' started by Harpoon, Aug 18, 2010.

  1. Harpoon

    Harpoon
    Vancouver Washington
    New Member

    Messages:
    6
    Likes Received:
    0
    I have recently became the owner of this gun and it has a couple of problems. The selector button does not work. My Bore Light lets me look into it and I can see a broken piece that looks like it has a shaft running through it. The trigger guard is also broken. Any one know where I can Fine parts for this gun? If it makes any difference, the barrels are mated together. I have seen some with a gap between them.
     
  2. toobigtofail

    toobigtofail
    PDX
    Member

    Messages:
    212
    Likes Received:
    1
    I think you're referring to Savage/Stevens Model 24 .22/410 over under. Is this correct?
     
  3. Harpoon

    Harpoon
    Vancouver Washington
    New Member

    Messages:
    6
    Likes Received:
    0
     
  4. Harpoon

    Harpoon
    Vancouver Washington
    New Member

    Messages:
    6
    Likes Received:
    0
    Thank you very much for the lead. I have heard of them but forgot all about them.
     
  5. Izzy

    Izzy
    Oakridge
    Active Member

    Messages:
    671
    Likes Received:
    86
    :thumbup:
     
  6. bcp

    bcp
    SW WA
    Member

    Messages:
    193
    Likes Received:
    3
    They MIGHT have a used part someone sold them. I had the same thing happen over 30 years ago. No parts were available then from Numrich or Savage. The solution was a later model hammer with a selector on the hammer.

    Bruce
     

Share This Page