- Messages
- 973
- Reactions
- 1,128
***SOLD***
I have an AR build for sale with quality parts. I am gauging interest in the rifle as it sits before I tear it down and sell separately.
The rifle started as a factory Colt 6721 built in 2008. The upper and lower receiver along with the BCG are the only parts that are left from the factory build. The receiver set and BCG have approximately 1000 rounds on them, but the rest of the parts have less than 50 rounds.
Build list:
UPPER-
-Colt "C" marked flat top upper receiver with Colt FA and Strike Aluminum Enhanced Dust Cover
-Colt "C" marked BCG
-Radian Raptor LT Charging Handle
-16" Larue Stealth Barrel with M4 feed ramps, mid-length gas system, and 1:8 twist
-SLR GB7 low profile gas block with mid-length gas tube
-PWS FSC556 Muzzle Brake
-Geissele MK13 15" Mlok Rail
LOWER-
-Colt Lower receiver with Colt parts (Receiver has Restricted LE roll marks)
-Large Pin Geissele SSA trigger with SSA-E springs (So basically an SSA-E trigger)
-Magpul FDE MOE Grip
-Magpul UBR Gen 2 Stock
-Spikes ST-T2 buffer
This gun shoots very well and Larue barrels are extremely accurate. Only getting rid of to fund other rifles and optics that I recently purchased.
This rifle was assembled by me and I am an AR15 armorer. Feel free to message me with any questions.
Asking $1150, buyer pays transfer. I can meet at an FFL of your choice in the Vancouver/Portland Metro area.
**Rifle case NOT included**
I have an AR build for sale with quality parts. I am gauging interest in the rifle as it sits before I tear it down and sell separately.
The rifle started as a factory Colt 6721 built in 2008. The upper and lower receiver along with the BCG are the only parts that are left from the factory build. The receiver set and BCG have approximately 1000 rounds on them, but the rest of the parts have less than 50 rounds.
Build list:
UPPER-
-Colt "C" marked flat top upper receiver with Colt FA and Strike Aluminum Enhanced Dust Cover
-Colt "C" marked BCG
-Radian Raptor LT Charging Handle
-16" Larue Stealth Barrel with M4 feed ramps, mid-length gas system, and 1:8 twist
-SLR GB7 low profile gas block with mid-length gas tube
-PWS FSC556 Muzzle Brake
-Geissele MK13 15" Mlok Rail
LOWER-
-Colt Lower receiver with Colt parts (Receiver has Restricted LE roll marks)
-Large Pin Geissele SSA trigger with SSA-E springs (So basically an SSA-E trigger)
-Magpul FDE MOE Grip
-Magpul UBR Gen 2 Stock
-Spikes ST-T2 buffer
This gun shoots very well and Larue barrels are extremely accurate. Only getting rid of to fund other rifles and optics that I recently purchased.
This rifle was assembled by me and I am an AR15 armorer. Feel free to message me with any questions.
Asking $1150, buyer pays transfer. I can meet at an FFL of your choice in the Vancouver/Portland Metro area.
**Rifle case NOT included**
Last Edited: