- Messages
- 4,091
- Reactions
- 13,283
Some excellent Mygrainman approved trigger here..
First is a BCM PNT(polishes nickle Teflon) VERY good Trigger!
BCM PNT Trigger Assembly AR15
$50
Even better... maybe the best single stage trigger I've ever used!
Fully adjustable down to ounces of pull and mm of reset!
It is very much like (and may be) the JP, but unlike JPs current offering, it's Nickel Teflon, and has tiny bushings in the pin holes allowing it to be used in large Pin (.170)or small pin(.154)lowers.
***99% of the lowers out there are small pin..large Pin are found mostly in ban era Colts FYI***
Install & adjustment instructions on JPs website.
Did not come with a hammer or pins, but I have a Milspec Hammer I'll throw in..
$65SOLD
Lastly:
Genuine Colt enhanced competition Trigger Group
Take off from a Colt 6724 HBAR Elite
Large Pin (.170)
If I had a large Pin Receiver I'd be running this.. it's a great trigger!
Low mass hammer, polished sere contacts, and I believe hard chrome finish... possibly early NiB?
Rare Find!
I put it in the jig and it averaged just over 4# by my scale.
I don't have the right pins though so your mileage may vary.
$65 SOLD
First is a BCM PNT(polishes nickle Teflon) VERY good Trigger!
BCM PNT Trigger Assembly AR15
$50
Even better... maybe the best single stage trigger I've ever used!
Fully adjustable down to ounces of pull and mm of reset!
It is very much like (and may be) the JP, but unlike JPs current offering, it's Nickel Teflon, and has tiny bushings in the pin holes allowing it to be used in large Pin (.170)or small pin(.154)lowers.
***99% of the lowers out there are small pin..large Pin are found mostly in ban era Colts FYI***
Install & adjustment instructions on JPs website.
Did not come with a hammer or pins, but I have a Milspec Hammer I'll throw in..
$
Lastly:
Genuine Colt enhanced competition Trigger Group
Take off from a Colt 6724 HBAR Elite
Large Pin (.170)
If I had a large Pin Receiver I'd be running this.. it's a great trigger!
Low mass hammer, polished sere contacts, and I believe hard chrome finish... possibly early NiB?
Rare Find!
I put it in the jig and it averaged just over 4# by my scale.
I don't have the right pins though so your mileage may vary.
Last Edited:
