Smith to cut Dovetail front and rear for sight upgrade.

Discussion in 'Maintenance & Gunsmithing' started by broncman, Jun 13, 2013.

  1. broncman

    broncman
    E. of Portland yet to close!
    Quality Control!

    Messages:
    626
    Likes Received:
    191
    I am looking for a Smith to mill down/off the front and rear sights on a LCP then cut dovetails for LC9 sights in the slide. Would also want to have serrations put on front of slide that are identical to the stock rear serrations.

    Suggestions welcome.
     

Share This Page