S&W 1006 / 4506 compatibility question

Discussion in 'Handgun Discussion' started by JedB, Jun 11, 2014.

  1. JedB

    JedB
    PDX
    Well-Known Member

    Messages:
    500
    Likes Received:
    304
    Does anyone know if the uppers on these can be interchanged?

    I have a S&W 1006 and am contemplating a 4506 upper so that way I can shoot both.

    Just curious if anyone has done this, and if so, how did you like it?
     
  2. pdxjazz

    pdxjazz
    Portland
    Active Member

    Messages:
    145
    Likes Received:
    78
    I'm not 100% sure but I don't think so. I remember reading in one of the forums where somebody had asked that question. I have a 4556 and wondered the same a while back and came across it. Something about the 10mm was beefed up in a couple areas which made them non-interchangeable.
     
  3. JedB

    JedB
    PDX
    Well-Known Member

    Messages:
    500
    Likes Received:
    304
    Thank you PDX -Jazz.

    So far the only differences that I have found is that the feed ramp, and the block under the barrel are marginally wider on the 4506 barrel.

    I haven't had the opportunity to look at a 4506 frame yet to compare it with my 1006 frame, but I'd be interested to see the differences.

    Anyone else?
     

Share This Page