Pistol sight issue!!

Discussion in 'Semi-Automatic Pistols' started by chrisk86, Oct 8, 2018.

  1. chrisk86

    chrisk86
    Spokane
    Member

    Messages:
    76
    Likes Received:
    18
    So I was out shooting my kahr cm9 with trijicon night sights and the front sight ended up popping off and unfortunately I was not able to find it, when I was at home trying to remove the screw so I couldn't replace the sight I noticed there appears to be red threadlock on the screw, how can I remove the screw without having to heat the slide up to remove the threadlock
     
  2. Reno

    Reno
    Hillsboro
    Silver Supporter Silver Supporter 2015 Volunteer 2016 Volunteer 2017 Volunteer 2018 Volunteer 2019 Volunteer

    Messages:
    6,563
    Likes Received:
    13,674
    Soldering iron tip to screw.
     
    JRuby, bbbass and KKG like this.
  3. Certaindeaf

    Certaindeaf
    SE Portland
    Sniper Bird! (What Retch Sweeney would say) Bronze Supporter

    Messages:
    14,136
    Likes Received:
    26,923
    Just stick the front of the slide in a toaster so the whole thing doesn't get heated up. lol
     
  4. KKG

    KKG
    Snohomish
    Well-Known Member

    Messages:
    3,566
    Likes Received:
    5,326
    Reno911 gave you the right answer. Just make sure you use the right screwdriver and take it slowly.
     
    JRuby and bbbass like this.
  5. chrisk86

    chrisk86
    Spokane
    Member

    Messages:
    76
    Likes Received:
    18
    Should I also hold the slide while it's in the toaster so it doesn't faze lol over I was also thinking maybe a hear gun but wasn't sure if it would discolor the slide but I'll try the soldering iron
     
    Certaindeaf likes this.
  6. edzz

    edzz
    CDA, ID
    Well-Known Member

    Messages:
    418
    Likes Received:
    940
    Contact Khar, see if they will fix their defective gun...
     
    308, KKG and JRuby like this.

Share This Page