Anyone ever have one of those days where you think you're being clever but it just goes much harder than it should, and wonder what bad juju karma is putting back on you.....
...then you have this crazy idea, "I wonder what the manual says?"... only to discover you're trying to reinvent the wheel?
There is already a procedure and specifications listed to mfg a special tool specifically for what you are trying to accomplish!!
(*Replace a take-down pin with zero disassembly)
I dunno why I never noticed before, but dang it all!
...then you have this crazy idea, "I wonder what the manual says?"... only to discover you're trying to reinvent the wheel?
There is already a procedure and specifications listed to mfg a special tool specifically for what you are trying to accomplish!!
(*Replace a take-down pin with zero disassembly)
I dunno why I never noticed before, but dang it all!