JavaScript is disabled
Our website requires JavaScript to function properly. For a better experience, please enable JavaScript in your browser settings before proceeding.
Messages
3
Reactions
0
Does anyone know the drill/thread depth for the three holes that are needed to install the factory scope mounting rail on an older Ruger MK II (target) pistol?
I am sure the hole further back (rear) is tapped clear through the receiver, but the forward two seem to be blind holes. Obviously don't want to go into the bbl. or chamber.
Appreciate any advice.
thanks
CFC
 

Upcoming Events

Lakeview Spring Gun Show
Lakeview, OR
Albany Gun Show
Albany, OR
Falcon Gun Show - Classic Gun & Knife Show
Stanwood, WA
Wes Knodel Gun & Knife Show - Albany
Albany, OR

New Resource Reviews

New Classified Ads

Back Top