Diamond Supporter
Gold Supporter
Silver Supporter
- Messages
- 3,566
- Reactions
- 6,638
- Thread Starter
- #41
Along these lines, i was searching last night and someone mentioned something and it made a lot of sense. At least "a lot of sense" in my limited knowledge of this.
Someone on the interwebs mentioned that Hornady One Shot is roughly $15 for a 5 or 7 oz can (depending on how you read the label).
Liquid wrench Silicon spray is $6 for an 11oz can. They said the silicon spray is super slick and works just as good. BUT, you must clean the brass inside and out after using it. (I assume that it lingers and can affect the powder?)
I normally run the brass through a wet tumbler with SS pins (and of course thoroughly drying them) before loading anyway (as my OCD only allows me to load clean shells ).
So, is there a reason the silicon spray can't work too?
Someone on the interwebs mentioned that Hornady One Shot is roughly $15 for a 5 or 7 oz can (depending on how you read the label).
Liquid wrench Silicon spray is $6 for an 11oz can. They said the silicon spray is super slick and works just as good. BUT, you must clean the brass inside and out after using it. (I assume that it lingers and can affect the powder?)
I normally run the brass through a wet tumbler with SS pins (and of course thoroughly drying them) before loading anyway (as my OCD only allows me to load clean shells ).
So, is there a reason the silicon spray can't work too?