- Messages
- 167
- Reactions
- 31
Found some 223 brass w/ FC headstamp. cleaned em up and when i measured them before trimming or sizing, they measured 1.733-1.736 on average
I know this is below the 1.750 trim to length
were these trimmed too far by someone? is this normal for this brass from the federal factory? should i reload these?
None of my once fired factory brass is anywhere near this short (example- shot some rem 55gr and they measured roughly 1.754 prior to trimming)
Thanks
I know this is below the 1.750 trim to length
were these trimmed too far by someone? is this normal for this brass from the federal factory? should i reload these?
None of my once fired factory brass is anywhere near this short (example- shot some rem 55gr and they measured roughly 1.754 prior to trimming)
Thanks