- Messages
- 2,948
- Reactions
- 2,214
Unless you're very meticulous about making sure you're picking up your brass and only your brass avoid the X-die. As it will smash any brass that isn't trimmed to the proper length (factory .223 brass tends to very _A_LOT_). The trimmer you guys are talking about is the Dillon RT1200 trimmer I mentioned earlier, it fits in a standard 7/8-14 die hole and uses a custom trim die with a 5K RPM motor driving a carbide cutter. It works pretty well, I use it quite a bit for .223 and .308 case processing. When doing higher quality ammo, I have a gracey bench trimmer that does a better job (actually chamfers the case mouth).