JavaScript is disabled
Our website requires JavaScript to function properly. For a better experience, please enable JavaScript in your browser settings before proceeding.
I have a 1911 end cap that's still MIA. Last spotted headed across the room at full afterburner. :rolleyes:

Agreed, I'm searching for one of those labritory enclosures that has the long rubber gloves that are attached to the window allowing one to assemble, view and recover those blasted projectiles when they let loose.:D
 
My first 80% was the cheapest polymer one I could find witch was a good choice because I @#$%&+? It up my second I got the polymer 80% kit that came with the jig and bits work 's good my AR pistol I have some aluminum ones that I have started but I need a better drill press and some good bits to finish it View attachment 352473 polymer 80 lower

Me too!! I wiped out two of them. One before I had a X-Y vise, and one because I used Loctite to retain the screws on the end of my trigger pins. (it ate the entire bit of polymer :() Polymer80 was nice enough to send me a free replacement. :)

The polymer build was used with my 10.5" barreled AR pistol. Works perfectly with the Hardened Arms upper.
 
Last Edited:
This:$6.95
Wheeler Delta Series AR-15 Pivot/Roll Pin Install Tool - 156243 - 661120562436

gns-402-016_1.tif&wid=480&cvt=jpeg.jpg
 

Upcoming Events

New Classified Ads

Back Top