Bronze Supporter
- Messages
- 8,644
- Reactions
- 12,918
OK my dirt cheap sand blasting cabinet
A lot of the materials I already had on hand including
all screws
all 2x2 lumber and other misc wood
the lamp
the Lexan
the piano hinge
the sheet tin and flashing
the old stove rack
the Glass from a photo frame
I had the air dryer from my old cabinet
The plumbing misc I used to make the vacuum hose port
And I had a portable sandblasting gun and the hose material
Additional items bought
1 Sheet 4 x 8 x 7/16" OSB $$11.50 (should have used 1/2" plywood for the extra $18.00)
I pair of harbor freight sand blast cabinet gloves $20
So I think I have like $32.00 into this Its way bigger inside then my old cabinet made from a small garbage can. I hated the gloves in it way to stiff and made my hands hurt when trying to hold smaller items and I couldn't get the gun far enough away from anything bigger.
Its 20" x 24" x 18/21" inside If I had it to do over besides spending the extra money on plywood I would have made the joints the other way around so I could have had the gloves 3" father apart. Would have been a little more comfortable. But this has got to be better then the old one and the hand cramps I got with it. Now to figure out where to put it. I think the Bandsaw is going to loose its spot and its going to take up the wall space between my man door and barn doors to the inner shop.
A lot of the materials I already had on hand including
all screws
all 2x2 lumber and other misc wood
the lamp
the Lexan
the piano hinge
the sheet tin and flashing
the old stove rack
the Glass from a photo frame
I had the air dryer from my old cabinet
The plumbing misc I used to make the vacuum hose port
And I had a portable sandblasting gun and the hose material
Additional items bought
1 Sheet 4 x 8 x 7/16" OSB $$11.50 (should have used 1/2" plywood for the extra $18.00)
I pair of harbor freight sand blast cabinet gloves $20
So I think I have like $32.00 into this Its way bigger inside then my old cabinet made from a small garbage can. I hated the gloves in it way to stiff and made my hands hurt when trying to hold smaller items and I couldn't get the gun far enough away from anything bigger.
Its 20" x 24" x 18/21" inside If I had it to do over besides spending the extra money on plywood I would have made the joints the other way around so I could have had the gloves 3" father apart. Would have been a little more comfortable. But this has got to be better then the old one and the hand cramps I got with it. Now to figure out where to put it. I think the Bandsaw is going to loose its spot and its going to take up the wall space between my man door and barn doors to the inner shop.
Last Edited: