300 Blackout Brass Processing Service

[JJE76]

Any recommendations on a good 300 blackout brass processing service? Ended up with 1000 plus FC 223 cases want to convert them to blackout. Was planning on loading them for 223 but would rather load blackout.

Read More

 

[Hooyah DeepSea]

Buy a chopper, jig, and dies, and do it yourself.

It's not hard, just a bit time consuming . . . but think of the pride of ownership !!! and the satisfaction of a job well done.

 

[John Gault]

Any recommendations on a good 300 blackout brass processing service? Ended up with 1000 plus FC 223 cases want to convert them to blackout. Was planning on loading them for 223 but would rather load blackout.

Sadly, Carolina Brass just quit....

 

[Caveman Jim]

Convo sent.
Sages Reloading Supplies in Auburn, Wa

 

[Newberg]

@JohnH

Send him a message. He helped me years ago.

 

[JohnH]

Thanks Buddy, hope all has been well with you and yours!!

Convo started

 

[VinnieBoomBah]

+1 for @JohnH He is a stand up guy and delivers an exceptional product at a more than fair price!

 

[kmk1012]

I'll second, or is it third @JohnH. I bought some converted from another member who didn't sort them first, what a headache, I gave those away. Bought some from John and all were perfect. Have been a multiple repeat customer to him over the last several years.

 

[Flounder]

I have used this guy. Very fair prices and quick turn around.

https://msprocessedbrass.com/

 

[JJE76]

Thanks for the help!

 

[jkor]

problem I have had with two places (likely all) is the de crimping process tends to push the flash hole out into the primer cup. Likely due to the need to de crimp multiple brands and a set up overly aggressive. If I did it again I would see if the de crimping process could be skipped.

 

[dirtyd]

I process all my 556 to 300. It's not that difficult with a miter saw and a jig...unless you dont have any reloading equipment to begin with.

 

[JJE76]

Thanks for all the replies! Talked with @JohnH going to meet up with him this week.

 

[kmk1012]

Thanks for all the replies! Talked with @JohnH going to meet up with him this week.

You won't regret it at all, @JohnH takes pride in his work!