JavaScript is disabled
Our website requires JavaScript to function properly. For a better experience, please enable JavaScript in your browser settings before proceeding.
Winchester M94 GS needed
- Thread Starter joken
- Start date
- Messages
- 413
- Reactions
- 51
Ammo Reloads?
Tell us more High or low feed? Round Not making it out of the Magazine? Need more Information to go on.............
Tony Portland, Oregon Area
Tell us more High or low feed? Round Not making it out of the Magazine? Need more Information to go on.............
Tony Portland, Oregon Area
- Thread Starter
- #3
Factory ammo. Mag feed is not reliable and the cartridge is high. The guides have been highly buggered with so I replaced them and did remove a bit from them, not much. Now it is low. The carrier appears low too and is pretty worn where it contacts the spring. Rifle was built in 1964. I ordered a new carrier and is different. It does fit however does not move when the bolt is cycled.
Want a project? I am not familiar enough with the peculiarities of this action to afford to play with it.
Want a project? I am not familiar enough with the peculiarities of this action to afford to play with it.
Last Edited:
- Messages
- 413
- Reactions
- 51
sound like you need to time the Carrier With the locking block and limit the rise of the carrier.
You know that most all parts must be fitted. The old one just may need to be bent some so it not go up so much. Tony
You know that most all parts must be fitted. The old one just may need to be bent some so it not go up so much. Tony
