- Messages
- 1
- Reactions
- 0
So I recently acquired an Vepr FM74 fixed stock and decided I wanted a fancy expensive Zenitco side folding stock. the only problem is that the side folder uses the Saiga sidefolding rear trunnion and the Vepr has a fixed stock rear trunnion and 1.5mm receiver. So I bought the stock and trunnion that goes with it. I need to find someone in the South Puget Sound area that i can mill .5mm off of each side of the trunnion to accommodate the tighter inside dimensions of the receiver and possibly template and drill/mill the sides of the receiver for the buttons on either side of the rear. I am aware I could have just bought an arsenal 107 or the like, but I am quite fond of the the heavier vepr rifle.