Silver Supporter
- Messages
- 10,199
- Reactions
- 17,548
I always tell people if you want a authentic yugo M92 use a Yugo stock. If you want a more comfortable to shoot underfolder use a Hungarian stock. Theyre pitched a couple of degrees down compared to the Yugo . Not as much as Romanian
I use a 5/8" carbide end mill for the main trunnion hole, a 6mm carbide end mill for the locking holes and 1/8" carbide end mill for the antirotation pin slots. After the main trunnion hole is located and bored I'll put a 1/8" collet in there with the carbide cutter and cut the slots so it doesn't lose place on the X axis. I generally locate the holes on each side with the edge finder and ream a few thousands through the bore. You really want to run carbide cutters on these . Those receiver work harden pretty bad with high speed steel.
Did this one today for a customer. Note the slight downward angle of the stock. Its a Hungarian . Yugos stick straight out and are nowhere near as comfortable to shoot.
I use a 5/8" carbide end mill for the main trunnion hole, a 6mm carbide end mill for the locking holes and 1/8" carbide end mill for the antirotation pin slots. After the main trunnion hole is located and bored I'll put a 1/8" collet in there with the carbide cutter and cut the slots so it doesn't lose place on the X axis. I generally locate the holes on each side with the edge finder and ream a few thousands through the bore. You really want to run carbide cutters on these . Those receiver work harden pretty bad with high speed steel.
Did this one today for a customer. Note the slight downward angle of the stock. Its a Hungarian . Yugos stick straight out and are nowhere near as comfortable to shoot.
![333048876_1167643333921227_3059727441317797824_n.jpg 333048876_1167643333921227_3059727441317797824_n.jpg](https://data.northwestfirearms.com/attachments/1094/1094336-a2307e536510cd0d23f713b3427746a6.jpg)