SOLD-Noveske 10.5" AR Pistol sold- with extras

Discussion in 'Handgun Classifieds' started by MinnesotaORnewbie, Dec 13, 2011.

Thread Status:
Not open for further replies.
  1. MinnesotaORnewbie

    Active Member

    Likes Received:
    Like New from Noveske 10.5" upper - have original box
    Like New lower from Tactical Machining
    LPK from Palmetto State Armory
    The gun has about 50 rounds through it without a single problem, cleaned and re oiled it and has sat for three months. The upper has a very nice tight fit, zero slop or play between them. Shoot it, piece it out, what ever, its ready to go
    On the Gun:
    Magpul Moe Hand grip
    Ace pistol buffer tube assembly
    Magpul AFG2 forward grip
    Viking Tactics rail mounted flashlight holder
    Magpul Front and Back MBUS sights
    Bravo company Gun Fighter Charging Handle
    Yankee Hill Machine Co. Midlength Diamond Forearm Rail System
    True Glo Red Dot
    Easy Tool less take down Pins

    Off the Gun:
    Viking Tactics Tactical gun case
    Bore snake barrel cleaner
    2 Magpul 30 round Clips, 1 Colt 30 rnd, and 1 10 rnd Clip
    150 rounds of ammo
    Single point sling
    Original Noveske Heat sheild Hand Guards
    Original A2 Front Sight
    Brand new Extra H2 Buffer and Spring
    Ar 15 Tool
    And a few Extra Misc. New parts

    This is a list from Noveske about the upper: Noveske Rifleworks, LLC. AR-15, M4, M16, AR-10 Variant Rifles, N4, N6, Leonidas, Recce Precision Battle Weapons -
    10.5" Cold Hammer Forged 5.56mm Barrel
    --M249 Machine Gun barrel steel and Chrome Lining (appx. 2 times as thick as an M4 or M16)
    --Extended Feed Ramps
    --MP HP tested
    --1 in 7" twist
    --Mil Spec Phosphate finish
    --Carbine length gas system
    --1/2x28 threads
    --Fixed front sight base, F marked
    --Flat-top upper receiver
    --Standard M4 type handguards
    --Shot peened and MP tested bolt
    --Auto carrier with properly staked carrier key
    --Gun Fighter Charging Handle
    --KX3 Flash Suppressor,(US pat #7,836,809)

    The lower receiver is made by Tactical Machining. Here is info from the company
    The Tactical Machining AR-15 lower receivers are built from mil-spec 7075-T6 forgings from the lead forge in the U.S. The contour is fully machined leaving no flash marks from the forging. We take extra care when machining our lower receivers resulting in tolerances that are tighter and fits that are better than other lower receivers.

    The lower was finished with a lower parts kit from Ammunition, Magazines, Rifle Parts and Accessories

    you can PM me or call me on my cell phone with any questions, thanks.
    Mark Haro
    can meet part way in Portland area
    Last edited: Dec 17, 2011
Thread Status:
Not open for further replies.

Share This Page