Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Thanks for a quick reply. The blocks and such are still in and the pins ect will need to be pressed out. I was hoping I could use a drill press after pressing in the barrel, but you say I'll need an endmill to make the notch? That'll complicates things a bit.Are all the blocks removed? Sight tower, gas block, rear sight block. Is it a new barrel without a barrel pin groove? If so you will need an endmill to cut the notch. I have the tooling to press both barrels but don't have an endmill.