Gold Supporter
- Messages
- 850
- Reactions
- 1,272
I have a 99% complete AR build, but can't seem to move past a single item roadblock… installing the gas tube into the gas block. The issue is getting a roll pin to drive through the small hole at the top of the block. I've tried crimping or sanding the end of the roll pin to help get it started, and it does….but when I try to get it to budge further, the roll pins will either start to bend, or smash. I am using a roll pin starter and a vice block
So after countless YouTube videos, 4 ruined pins, 2 trips to Mazamas for Aero AR fix it kits I'm now at a frustration point lol my questions are…does anyone have any best practices to share? Or is there anyone local in Eugene area that can help install? im happy to pay cash.
Ps. Yes I know there are gunsmiths locally, but wait lists are several weeks long, so hoping to find amateur peer assistance.
Thanks in advance for any help or advice.
So after countless YouTube videos, 4 ruined pins, 2 trips to Mazamas for Aero AR fix it kits I'm now at a frustration point lol my questions are…does anyone have any best practices to share? Or is there anyone local in Eugene area that can help install? im happy to pay cash.
Ps. Yes I know there are gunsmiths locally, but wait lists are several weeks long, so hoping to find amateur peer assistance.
Thanks in advance for any help or advice.