AR10 ejector spring

Discussion in 'Maintenance & Gunsmithing' started by edslhead, Apr 7, 2015.

  1. edslhead

    edslhead
    Vanc
    Platinum Supporter Platinum Supporter Silver Supporter

    Messages:
    2,849
    Likes Received:
    6,929
    Is there a set pressure range for the 308's ejector spring? I was getting brass bits around the feed ramps on mine and the bolt had trouble locking up so I cut 3 rings off the spring. Then it wouldn't eject the shell in time and the thing would jam. I got new springs and cut 2 rings off and now it works fine. Just was wondering if there's a set pressure for it and a way to check that or do you just dink around with it till it works,, like I did?
     
  2. IronMonster

    IronMonster
    Free Idaho!
    Opinionated Member Bronze Vendor Lifetime Supporter

    Messages:
    5,432
    Likes Received:
    11,031
    Get a hold of "unclemoak" here or send him a email on his web page

    D.Wilson Manufacturing

    He builds .308 BCG's, if anyone can give you a real answer I bet it's him
     
  3. edslhead

    edslhead
    Vanc
    Platinum Supporter Platinum Supporter Silver Supporter

    Messages:
    2,849
    Likes Received:
    6,929
    I'll do that , thanks.
     

Share This Page