91/30 rework

Discussion in 'Maintenance & Gunsmithing' started by ernurse, Sep 30, 2015.

  1. ernurse

    ernurse
    molalla oregon
    Active Member

    Messages:
    293
    Likes Received:
    178
    Took an old m91/30 I had sitting in the safe wasting away, and did the following....

    cut four inches off the end of the barrel, recrowned with 11 degree cut.
    new ATI Monte Carlo stock.
    AIM 2-6 x 24 long eye relief scope.
    UTG mosin nagant rear sight mount.
    Had the bolt modded by Big Gorilla Gunworks, they cut off the old straight knob, then fabricated and tig welded a new low profile, backward swept, sniper style bolt handle.
    4 colors of duracoat and some elbow grease. Now it looks great and is holding 1 inch at 50 yards. hopefully itll stay small when I try it out at longer distances.
    I did everything but the bolt mod.
    011.JPG

    010.JPG

    013.JPG

    015.JPG
     
    Oathkeeper1775, bolus and Southpaw like this.
  2. Sgt Nambu

    Sgt Nambu
    PDX OR
    Silver Supporter Silver Supporter

    Messages:
    10,005
    Likes Received:
    20,564
    Looks sharp, good job!:)
     

Share This Page