Quantcast
  1. Sign up now and join over 35,000 northwest gun owners. It's quick, easy, and 100% free!

:)

Discussion in 'Rifle Classifieds' started by 7.62 maniac, Feb 14, 2010.

  1. 7.62 maniac

    7.62 maniac Portland Member

    Messages:
    240
    Likes Received:
    20
    :)
     
  2. 7.62 maniac

    7.62 maniac Portland Member

    Messages:
    240
    Likes Received:
    20
    Btt
     
  3. Spitpatch

    Spitpatch Forest Grove, Oregon Well-Known Member

    Messages:
    1,801
    Likes Received:
    836
    What's the story on the Magnum 1100's as far as shooting 2 3/4 shells. I know the 11-78 was the improvement, and I think I understood that you had to put some sort of different piston in a Magnum 1100 to shoot standard shells. ?? Any info on that?
     
  4. 7.62 maniac

    7.62 maniac Portland Member

    Messages:
    240
    Likes Received:
    20
    I don't know anything about a different piston. The older 1100's had 2 gas ports on the standard 2 3/4, and only one on the 3" magnums. I don't think it would be very hard to modify the magnum by drilling another port to cycle 2 3/4" shells reliably. This 1100 will cycle some 2 3/4" high base rounds, and some heavy game loads. It does not cycle the lightest 2 3/4 target loads, but then again neither does my 11-87 that is rated for 2 3/4.
     
  5. 7.62 maniac

    7.62 maniac Portland Member

    Messages:
    240
    Likes Received:
    20
    Btt
     
  6. elkcraz

    elkcraz oregon Member

    Messages:
    36
    Likes Received:
    0
    pm sent
     
Thread Status:
Not open for further replies.