WTS OR Winchester 94 Pre 64 30 30

[johnboy]

Very good condition and bluing very good. My Father purchased new in 60 or so and have tried to find out exactly with serial number (2472473) but no luck. Been in safe for 20 years and has been cleaned and well taken care of. Can see no real signs of any rust but possibly around small screws. Just want fair value so best offer near $750 or convince me it is worth less. Have just checked a few other sites for values but open to negotiation. My guess is 30 rounds fired as my Father was way more collector than shooter......thanks

sold sold sold sold

Read More

 

[amusicman2]

Hi. Very nice. My book and the dater I use puts it as a 1961.

 

[johnboy]

Thanks alot, I appreciate it !!!

 

[johnboy]

The recoil pad will lower the value somewhat...

 

[slingshot1943]

Was stock cut down for recoil pad? I have one that came with a recoil pad but hadn't been cut.

 

[johnboy]

Not sure, guess I can take it off and see/check.....but do not have the metal piece for butt

 

[slingshot1943]

Check length of pull. Mine are 13" to end of wood.

 

[jbett98]

If uncut, then it should measure around 4-5/8" X 1-5/8".

 

[USAF Medic]

PM sent

 

[johnboy]

12.5-12.75 to end of wood is what I get...maybe it was cut....cannot find a way to remove the pad....no screws visible...

 

[jbett98]

There should be two tiny holes that self seal over the opening when the screw driver is removed. Dead center and 1/4 of the way from top and bottom.