Winchester 1300 Defender HD gun 20 gauge for HD 12 gauge

Status
Not open for further replies.
Messages
611
Reactions
21
Feedback: 17 / 0 / 1
I have a Winchester 1300 Defender HD type gun in 20 gauge that I want to trade for an HD type gun (7 round mag, 18-20" barrel, etc..) in 12 gauge, a 9mm semiauto, or a .357 magnum revolver. I just got this in on a trade, and wasn't aware it was 20 gauge. It is in basically brand new condition, looks to have not been fired more than 20 times, if fired at all. Has some wear on the receiver. Pretty sweet, sling swivel studs, TRUGLO front sight, 7 round mag capacity, synthetic buttstock. Will entertain other offers, handguns, etc... Value is around $275ish. FTF in Portland, OR only.
 
Status
Not open for further replies.

UPCOMING EVENTS

Arms Collectors of SW Washington Gun Show
Battleground Community Center
912 E Main St, Battle Ground, WA 98604, USA
DRRC .22 Rimfire Challenge Oct 10
Douglas Ridge Rifle Club
27787 OR-224, Eagle Creek, OR 97022, USA
Oregon State Steel Challenge Championship
Central Oregon Shooting Sports Association
Millican, OR 97701, USA
Miller's Quarry Clean-Up
Miller's Quarry
Miller Rd, Mt Hood Village, OR 97067, USA
Free Firearms Safety Course (I-1639 Compliant)
Virtual Webinar (Zoom)
Seattle, WA, USA

LATEST RESOURCE REVIEWS

  • J&B Firearm Sales
    5.00 star(s)
    Good local shop
    Picked up a rifle yesterday from J&B. This was the second or third gun purchase over the last few years from them. I always enjoy stopping by...
  • H&K Gun Shop
    5.00 star(s)
    The only place I have found 9mm in stock
    I’ll admit I didn’t even know this place existed, as I don’t tend to go into Forest Grove often. But it’s a giant (looks bigger from the...
  • Revelation Arms
    4.00 star(s)
    Depends who answers the phone
    I was given the number to Roger Loock by Beaver Creek Armory, as I needed parts I had ordered from MCarbo installed on a Kel-Tec Sub2000. On my...
  • Coastal Farm & Ranch - Cornelius
    3.00 star(s)
    Lesson learned
    I’ll take some responsibility here, as I took the employee at their word instead of doing a thorough inspection. Short story is that I asked for a...
  • MK Tactical
    5.00 star(s)
    Good guys!
    I stop in here every once in a while to see what Michael has in the clearance section, and to ask questions when I have a project in mind...
Top Bottom