- Messages
- 352
- Reactions
- 234
I am selling my 338 Edge (aka .338-300ultra). The rifle was built by Jim See withhttp://www.centershotrifles.com/ and is an absolute tack driver.
The rifle has about 250 rds down the tube and will shoot consistantly shoot 1/2 moa or better with the occasional groups in the 1/4 moa range with my handloads. Typical 100 yard groups are three rounds touching and my best long range group measured just under 2" center to center at 610 yards (yes I had a witness, and no he wasn't drinking). Rifle was properly broke in per Jim's instructions and barrel has never been heated up or shot more than about 20 rds without cleaning with Bortec. Rifle has been down a couple canyons and has a few very minor marks in the finish and could easily be touched up.
$1900.00 shipped, $1850.00 FTF. The scope, rings, and bipod are not for sale. The only reason I'm selling is to fund another build by Jim. Please feel free to email or PM any questions. First "I'll take it".
Thanks,
Doug
[email protected]
338 Edge specs:
Fully blueprinted C-series Remington 700 LA (smoothest Rem Action I've ever felt)
PTG bolt knob
Badger Ordinance 20 moa steel base epoxy bedded to action
Tuned Rem Trigger
Badger Recoil Lug
Brux 28" 1-10 twist, SS, Medium Palma Contour barrel
Center Shot Rifles muzzle break
Wyatts Extended mag box
magpul FDE duracoat finish
McMillan HTG fiberglass stock, GAP camo, bedded to action
Defensive Edge adjustable cheek piece
Weighs 12.6 lbs with NF scope on it
Handload:
300 grain SMK
90 grains of H1000
CCI 250 primer
Rem brass
OAL 3.775"
2745 fps
The rifle has about 250 rds down the tube and will shoot consistantly shoot 1/2 moa or better with the occasional groups in the 1/4 moa range with my handloads. Typical 100 yard groups are three rounds touching and my best long range group measured just under 2" center to center at 610 yards (yes I had a witness, and no he wasn't drinking). Rifle was properly broke in per Jim's instructions and barrel has never been heated up or shot more than about 20 rds without cleaning with Bortec. Rifle has been down a couple canyons and has a few very minor marks in the finish and could easily be touched up.
$1900.00 shipped, $1850.00 FTF. The scope, rings, and bipod are not for sale. The only reason I'm selling is to fund another build by Jim. Please feel free to email or PM any questions. First "I'll take it".
Thanks,
Doug
[email protected]
338 Edge specs:
Fully blueprinted C-series Remington 700 LA (smoothest Rem Action I've ever felt)
PTG bolt knob
Badger Ordinance 20 moa steel base epoxy bedded to action
Tuned Rem Trigger
Badger Recoil Lug
Brux 28" 1-10 twist, SS, Medium Palma Contour barrel
Center Shot Rifles muzzle break
Wyatts Extended mag box
magpul FDE duracoat finish
McMillan HTG fiberglass stock, GAP camo, bedded to action
Defensive Edge adjustable cheek piece
Weighs 12.6 lbs with NF scope on it
Handload:
300 grain SMK
90 grains of H1000
CCI 250 primer
Rem brass
OAL 3.775"
2745 fps
Last Edited:
