S&W 5906TSW (SOLD)

Discussion in 'Handgun Classifieds' started by benja455, Sep 7, 2012.

Thread Status:
Not open for further replies.
  1. benja455

    benja455
    Seattle, WA
    Member

    Messages:
    406
    Likes Received:
    23
    Sold!
     
  2. Chipperxd

    Chipperxd
    Buffalo
    Active Member

    Messages:
    711
    Likes Received:
    192
    quick question. Can you buy replacement mag release for this pistol?
     
  3. benja455

    benja455
    Seattle, WA
    Member

    Messages:
    406
    Likes Received:
    23
    The broken piece of metal (drill bit?...pin?) is inside the frame (where the magazine release fits when you reverse it). The magazine release functions perfectly fine...but from the right side of the gun (for a left handed shooter). It should be reversible, but there's a piece of metal lodged inside the milled out hole for the magazine release on the left side (for a right handed shooter). The metal is flush with the frame, so it doesn't interfere with anything else but it also cannot be drilled out, pulled out or punched out.
     
  4. Chipperxd

    Chipperxd
    Buffalo
    Active Member

    Messages:
    711
    Likes Received:
    192
    oh I see. I thought you meant it was just stuck on the left because of a broken piece.
     
Thread Status:
Not open for further replies.

Share This Page