PDX pin-and-weld

[SOLID_arity]

Assuming this is the right sub-forum to be inquiring, but does anyone know of a gunsmith in the greater PDX area that does pin-and-welds to get a 14.5" up to a 16"? How much does this service usually run?

Thanks in advance!

Read More

 

[jbett98]

I know that Curt's Discount Shooters Supply has a guy do that process.
A member here on the forum is a great gunsmith, and lives out in Estacada, goes by "Velzey".
I don't know what his work load is lately, but Curt's takes about a week to turn around.

Just make sure that you show whoever does the work, the exact position you want the flash hider or other extension to be in.

 

[Velzey]

That service usually runs right about 40-50$
Turn around time for that will be quicker than Curts!