- Messages
- 3,560
- Reactions
- 9,382
... for a K frame S&W Model 10.
The new grip panels (Altamont) are quite a bit slimmer than the factory panels so the threads stick-out on the right side
Ouch.
I can find regular length screws (1.15") but it looks like I need something 1/4-3/8" shorter.
Cutting one down is a possibility, but I don't think I would get enough thread engagement. Also, even cleaned-up theres a good chance of boogering-up the female threads of the off-side bushing (brass).
Any help?
The new grip panels (Altamont) are quite a bit slimmer than the factory panels so the threads stick-out on the right side
Ouch.
I can find regular length screws (1.15") but it looks like I need something 1/4-3/8" shorter.
Cutting one down is a possibility, but I don't think I would get enough thread engagement. Also, even cleaned-up theres a good chance of boogering-up the female threads of the off-side bushing (brass).
Any help?
