- Messages
- 2,628
- Reactions
- 4,001
I've done a lot of casting, but never tried to resurrect a mold. I was given this rust covered Lyman 90gr. .357 mold along with a bunch of other water-logged reloading gear.
Do you think it's worth trying to salvage? I was thinking of casting a few bullets with the mold, then slathering them with fine polishing compound and turning them with a drill. Are they too far gone to be worth the effort? This is not a bullet I would use much, but it could be fun to make duplex and triplex loads if I can get the mold to function.
Any thoughts and ideas would be appreciated.
Do you think it's worth trying to salvage? I was thinking of casting a few bullets with the mold, then slathering them with fine polishing compound and turning them with a drill. Are they too far gone to be worth the effort? This is not a bullet I would use much, but it could be fun to make duplex and triplex loads if I can get the mold to function.
Any thoughts and ideas would be appreciated.
Last Edited: