WTS WA Fusion Commander w/Rail 1911

Discussion in 'Handgun Classifieds' started by code420, Feb 3, 2016.

Thread Status:
Not open for further replies.
  1. code420

    Puyallup, WA
    Active Member

    Likes Received:
    image.jpeg i am testing the waters here to see if there is much interest. Long story short, I bought this Fusion Commander w/light rail as a incomplete pistol kit. The gun assembled at SouthRidge Arms using only the finest 1911 parts on the market. I am the original owner and built it to my specs. I have fired roughly 300 flawless rounds through it and it was carried more than fired. The trigger breaks at a clean 3.5" and the reset is very crisp with little to no over travel.

    Here is the breakdown of parts used:
    -Fushion frame, slide, stainless match barrel, grip safety and barrel bushing
    -Ed Brown checkered mag well, 3 hole trigger and ambi-safety
    -Cylinder & Slide hammer, sear and disconnector
    -Heinie front and rear Tritium Sights
    -Wolfe Springs
    -(2) WC magazines
    -VZ grips
    -KG Guncote flats grey with flat black controls

    I have about $2100.00 invested in this and I was asking $1500.00 and NOW $1300.00. I will also consider trades for the right AR10 or AR15 rifle. Please NO garage built guns, factory built only.
    Transaction to take place at agreed FFL in Pierce County as all I594 rules apply.
    Last edited: Feb 10, 2016
Thread Status:
Not open for further replies.

Share This Page