DW Bruin Firing Pin Problem.

benchmark · Oct 13, 2022

Ugh my DW Bruin firing pin channel is either not sized right or the firing pin is bent from the factory. Gun has never been fired. The pin itself doesn't fall freely into hole and when it does go in with the spring on it will not seat properly. Dunno. I have an email out to DW to confirm what the diameter is for a new pin, but if someone knows I'm all ears. Also, if I buy a new firing pin stop does it have to be one made for adjustible sights like this one from EGW or can it have the radius?

Oversized Firing Pin Stop Series 70 9/38/40/10 SS (Cut for Adjustable Sight)

Material: Stainless SteelCaliber: 9/38/40/10mmSeries: 70Hardness: 48 RcDrop In: NoMade to fit slides with a rear Bomar cut.EGW firing pin stops are wider than normal to prevent extractor from turning, which leads to more reliable ejection. Also, the firin

www.egwguns.com

trevi · Oct 14, 2022

I am sure DW will take care you. I think their warranty is 5 years. Never had to send my DWs in but my Specialist seemed like it might, has a "sticky" slide, even at near 400 rounds.