1911A1 for pistol

Discussion in 'Handgun Classifieds' started by AR15travis, Apr 10, 2009.

Thread Status:
Not open for further replies.
  1. AR15travis

    AR15travis
    Snohomish county
    New Member

    Messages:
    7
    Likes Received:
    0
    gone
     
  2. yotehunter

    yotehunter
    north west
    Active Member

    Messages:
    624
    Likes Received:
    47
    What is needed in "finishing work"? I have never built one before
     
  3. Grizzly_A

    Grizzly_A
    Portland Metro Area
    Member

    Messages:
    866
    Likes Received:
    17
    You'd need access to a milling machine (or nice drill press), a rail cutter, drill bits, jig, etc. to convert the "hunk of metal" into a receiver. 80% of the machining has been done, the 20% is up to you.

    Fun project if you've got the stuff to complete it. It would have to be completed by you ONLY.

    Since everything that is listed are only "parts" and hunk of metal there's no FFL transfers needed or paperwork needed. If you can trade or sell a paperweight to someone in another state, this qualifies.

    If I only had a SR9 for trade..... :(
     
Thread Status:
Not open for further replies.

Share This Page